We switched to UG NX 8.0 a week ago and I notice that when I check properties on a solid body it doesn't show the material property even though it is assigned. Do I have to create a new attribute or do I not have something turned on? When I go into the "assign material" function it shows that all bodies have a material assigned. It just won't show up on the properties.
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Material Properties not showing up
- Thread starter gcrow
- Start date
Check : File - Utilities - Customer defaults - Site( if used)- Gateway - Material/Mass : Create Attribute ? etc etc
Is this what you are looking for ?
If you have the material assigned, it should also report if you do Information - Object ( without the attribute )
Regards,
Tomas
Is this what you are looking for ?
If you have the material assigned, it should also report if you do Information - Object ( without the attribute )
Regards,
Tomas
- Status
