Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SSS148 on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Mercury Removal from Produced water

Status
Not open for further replies.

123engr

Chemical
Dec 10, 2012
35
Good day all,

A professional friend of mine asked me the question below. Since, I have no idea, I chose to share it you all for advise.

We have a maximum load of mercury in the discharge produced water stream of 0.2µg/l (micrograms per liter) against a minimum spec of 0.05µ/l.

Can we find any technology to get 0.2 to 0.05?


Thanks for your contribution.

I am what I am by His grace
 
Replies continue below

Recommended for you

Granulated carbon is often used to polish treated mercury solutions with varying success, but will not come close to the proposed limits.

Mercury is one of those compounds where there is a "fear factor" associated with it (like asbestos) and where it is also possible to detect extremely small amounts in water. With those elements, one can be sure that mercury will be an issue.

To remove mercury, sulfide precipitation is a reliable technology that is capable of meeting extremely low discharge requirements. Siemens has a treatment scheme presented in the link below that utilizes sulfide precipitation.

There are other mercury technologies such as resins, carbon, etc. My understanding is that sulfide precipitation is probably the best core technology.

Bench and pilot testing will be critical for the success of an application.




Siemens has been successful in removing mercury to less than 20 ppt with sulfide precipitation. Precipitation is not a standalone technology, it is used in combination with filtration and other technologies.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor