MicroStation J (Ctrl+I) 1

[surveli]

Is there a way to change my settings so that i may view a bearing for a lines direction instead of an azimuth? It differs from dgn to dgn on this pc and i dont know what it is i need to do in order to find out the bearing. TIA

 

[cveg05]

Go to -Settings-DesignFile then select the working units tab and at the bottom there should be an option to choose between bearing/azimuth/conventional. Don't forget to go to File-SaveSettings before you close file to keep settings

 

[surveli]

cveg05, thanks a zillion!!