Mimics V 10.01 and Abaqus Volume meshing problem

[Carloshv]

Hello everyone

I have been trying to import into abaqus a mandibular model using .inp file to do a volume meshing because mimics V 10.01 does not do it.
But i keep getting an error when a try to convert from tri to tet: The tet mesher detected intersections among the highlighted elements.
Use mesh editing tools to fix the intersections and try again.

Can someone help with this matter, I attached a screen picture.

Thank you.

 

[IceBreakerSours]

As far as I recall, using Mimics, you should be able to do volume meshing.

*********************************************************
Are you new to this forum? If so, please read these FAQs:

http://www.eng-tips.com/faqs.cfm?fid=376

http://www.eng-tips.com/faqs.cfm?fid=1083

 

[Carloshv]

You can not do volume meshing in Mimics V 10.01

 

[IceBreakerSours]

Correct! They started having those capabilities only after v12.

*********************************************************
Are you new to this forum? If so, please read these FAQs:

http://www.eng-tips.com/faqs.cfm?fid=376

http://www.eng-tips.com/faqs.cfm?fid=1083