Multi Hole Creation,,, 1

[sjkim]

I create 4 hole in a Hole Feature.
But, It's not recognized to Pattern..

In this case, not support the pattern count in drafting->Radial Dimension->Hole Callout Method,,,
And,, Not Support Assembly Pattern,,,
Is this true?

I know solid edge is support this,,,
Why NX is not support?

 

[MR76]

DID YOU ACTUALLY MADE PATTERN TO CREATE HOLES?

mr76

 

[sjkim]

No,, I created only one hole feature,,,(See my part navigator)

I know, if i create a hole and create a pattern feature, and then support this,,,,

But, hole feature support multi Hole,, And I want multi hole is recognized to pattern..

 

[JohnRBaker]

I would like multiple holes recognized as a 'pattern' as well, but they're not. If you would like to see this behavior in a future version of NX, please contact GTAC and have them open an ER (Enhancement Request) to this effect.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Digital Factory
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.