Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Multistage Pump Intermediate Bush

Status
Not open for further replies.

turbo05

Mechanical
Jun 20, 2005
6
In Multistage pump of Flow Serve/Ingersoll Dresser Make,4WDXR7 Model , 7 stages ,In which Near 4 th stage casing Bush & shaft sleeve design is there.In which bush got damaged.Bush to casing what type of fit & its valuee are unknown.Any body Please share your comments/advices.
 
Replies continue below

Recommended for you

Always start with ISO 286 on fits and tolerances. You'll need to select an interference fit to the housing. The bushing wall thickness is going to vary depending on whether you are willing to machine after installation.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor