Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

NACE 100 PPM Chlorides 1

Status
Not open for further replies.

Downhand

Industrial
Dec 20, 2009
59
CA
I have been told that there is NACE documentation that states up to 100 ppm chlorides for test media is acceptable when hydrotesting stainless steel. I have searched the NACE MR0175 and have had no luck finding this information. Can someone point me in the right direction?
 
Replies continue below

Recommended for you

Can't think of a NACE document (MR0175 is most certainly not applicable), but can only recall NORSOK L-004 imposing a chloride limit which is 50 ppm. Will keep looking.

Steve Jones
Materials & Corrosion Engineer

 
I must be getting bad information. I did find the 50 ppm in Norsok L-004 so thank you for that.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top