Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Negative for pipes

Status
Not open for further replies.

afa13

Mechanical
Jul 19, 2012
56
Does anyone know what does the term "negative for pipes" mean? once i read that a 2.5 inches negative is needed for the pipe....it has nothing to do with pressure....could it be an insulating layer? can someone give more explanation about this topic?
 
Replies continue below

Recommended for you

Only thing that makes sense to me would be buoyancy, but that is a really small number.

David Simpson, PE
MuleShoe Engineering

"Belief" is the acceptance of an hypotheses in the absence of data.
"Prejudice" is having an opinion not supported by the preponderance of the data.
"Knowledge" is only found through the accumulation and analysis of data.
The plural of anecdote is not "data"
 
clearance? (actually, might need to ask who wrote to know for sure!)?
 
Slope (ie, over some distance)? Clearance? For every pipe you install, you have to remove 2.5 pipes?

 
afa13
So far the comments are all over the map and do not answer the question.
"negative for pipes"

afa13 why don't you provide us with the complete wording (the whole paragraph) of where this was used and tell us what kind of document (Code, Standard, Procedure, Work Instruction, etc) it was used in.

prognosis: Lead or Lag
 
undercut, for bedding? (but kind of odd number!)


 
it was on the e-how site ... i cant find it anymore... it isnt in any standard... this is why i got so frustrated! i thought it was some sort of onsite "slang" for technical terms! still i can't figure it out!
 
I think the big thing is that, without the context and the sentence that the phrase appeared in, it could mean just about anything.

 
"The blind leading the blind" comes to mind.

Good luck,
Latexman

Need help writing a question or understanding a reply? forum1529
 
after careful examination of the term...i think that a sleeve is the closest and most appropriate answer for the term
 
well that sounds as good as any other explanation, about as useful as tits on a bull.

It is a capital mistake to theorise before one has data. Insensibly one begins to twist facts to suit theories, instead of theories to suit facts. (Sherlock Holmes - A Scandal in Bohemia.)
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor