DipakPatil333
Industrial
I am working in NX8,5.
I am not able get automatic centerline for the bolt circles using "Pattern Feature" as a circular instance in NX8,5
It creates simple center lines
But when i was using previous version NX6 that the command was different "Instance Feature" there i use to get the automatic bolt circle center lines
Did is there any way of doing it in NX8,5 or no option.
Please answer.
I am not able get automatic centerline for the bolt circles using "Pattern Feature" as a circular instance in NX8,5
It creates simple center lines
But when i was using previous version NX6 that the command was different "Instance Feature" there i use to get the automatic bolt circle center lines
Did is there any way of doing it in NX8,5 or no option.
Please answer.