Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Number of passes

Status
Not open for further replies.

mirhosseini

Industrial
Dec 4, 2003
20
As you know, for groove area an increase or decrease > 25% in number of passes needs prequalification.
I want to know Where the number of passes mention in WPS?


Regards
H.Mirhosseini
 
Replies continue below

Recommended for you

Correct post
As you know, for groove area an increase or decrease > 25% in number of passes needs requalification.
I want to know Where the number of passes mention in WPS?


Regards
H.Mirhosseini
 
With the 2004 edition of AWS D1.1, this requirement for requalification has been dropped.
As to where the pases are shown, see the examples in Annex E of the Code. The pass count should either show up in the sketch and/or listed in the table if there are variations between passes. The PQR must show more information regarding pass data, than a WPS might need.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor