NX 12 (2012) commands..... 2

[CAD2015]

Hi,

Last when I used NX was release NX9.
I started using NX again, but I need some time to get it back.
For instance, I can't find the sketch constrain command.
How could I get it?

Thank you,

CAD 2015

 

[SDETERS]

Look up the new sketcher vs legacy sketcher, you are seeing the new and improved sketcher, there are videos and more information on youtube and siemens Forums. Or do what everyone else is doing, go to file utilities and early access features and turn this off, and use the legacy sketcher. Especially in NX2012 when the new sketcher was released and it was really rough in its early stages.

 

[CAD2015]

SDETERS:
Thanks a lot for your prompt answer.
I had very good skills on the previous NX versions (up to NX9), and I thought that intuition and previous experience would be enough to get back to my favorite CAD software.
But it's not like that......

CAD 2015