NX 12 MOI (moment of inertia) section inertia tool.

[Blase_McK]

So I need to do a section of inertia on a part that has a threaded hole that runs thru the entire part.

when using the section inertia tool it has the option for solid or hollow. when you choose hollow it asks for a "hollow thickness"
what thickness is it wanting exactly? the OD of the thru-hole or the thickness between the OD of the thru-hole and the OD of the part?

Thanks
Blase

 

[greenimi]

Would be better and you will get more pertinent answers if you post your question on an NX forum.

Siemens: UG/NX

https://www.eng-tips.com/threadminder.cfm?pid=561

 

[Blase_McK]

Thanks! Don't post on here much so I wanst sure where to post it.

Thanks
Blase