Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

NX 6.0 Weld symbols

Status
Not open for further replies.

TomLoughlin

Military
Mar 14, 2014
18
Morning Chaps,

Just a quick question I hope:

I have put in a weld symbol onto a drawing, and it doesn't look right to me (or the checker). My issue is with the flat/convex symbol above the weld type - it looks too far away/misaligned.

It isn't a show stopper, but thought I would ask the question on here.

See attached pic or my drawing:

getfile.aspx


And pic of what I am aiming to achieve from BS22553:1994:

getfile.aspx


Cheers

Tom
 
Replies continue below

Recommended for you

This issue appears to have been addressed with NX 7.5.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.
 
Ah right, thanks John.

Will have to tell the checker that's just the way it is for now then.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor