StJudas
Aerospace
- Apr 2, 2013
- 9
I'm having an issue sending STP files created from CATIA to a customer using NX 7.5, where they will get multiples of one component in the assembly and the others will not show. We also have NX 7.5 and I am able to pull up the files with no issue at all.
When they open the step file they receive this error and overlapping parts:
“! STATUS- doing final check of body to report any faults
! STATUS-
! WARNING- solid body contains fault: 13805 - RTSTGX: Self-intersecting face surface
! WARNING- solid body (Unnamed) contains faults that could not be corrected
! WARNING-
! INFO- Filing Part ..: Z:\----\STP-files-7-30-13\-----_1
! ERROR- Unable to archive Z:\----\STP-files-7-30-13\-----_1:
! ERROR-
! ERROR- File already exists”
For this reason I sent NX 7.5 files created from the STP file, which come in flawlessly at our facility.
However when they try to open them UG pulls in one detail in the place of another so that instead of an assembly with 2 different parts they see 1 part in 2 locations. They also cannot open the 2 details at the same time or an error stating "You chose to open Z:\----\UG_FILES_7-30-13\-----_2.prt. Another version of the same part is already loaded: Z:\----\UG_FILES_7-30-13\-----_1.prt"
To me this makes no sense, especially since the files are opening correctly on our end. Has anyone else had any experience with this or have an idea as to what might be happening?
Unfortunately I cannot give much detailed information due to confidentiality.
Mold Design: Pro Engineer
Product Design: Solidworks
Aircraft Tooling: Catia V5
When they open the step file they receive this error and overlapping parts:
“! STATUS- doing final check of body to report any faults
! STATUS-
! WARNING- solid body contains fault: 13805 - RTSTGX: Self-intersecting face surface
! WARNING- solid body (Unnamed) contains faults that could not be corrected
! WARNING-
! INFO- Filing Part ..: Z:\----\STP-files-7-30-13\-----_1
! ERROR- Unable to archive Z:\----\STP-files-7-30-13\-----_1:
! ERROR-
! ERROR- File already exists”
For this reason I sent NX 7.5 files created from the STP file, which come in flawlessly at our facility.
However when they try to open them UG pulls in one detail in the place of another so that instead of an assembly with 2 different parts they see 1 part in 2 locations. They also cannot open the 2 details at the same time or an error stating "You chose to open Z:\----\UG_FILES_7-30-13\-----_2.prt. Another version of the same part is already loaded: Z:\----\UG_FILES_7-30-13\-----_1.prt"
To me this makes no sense, especially since the files are opening correctly on our end. Has anyone else had any experience with this or have an idea as to what might be happening?
Unfortunately I cannot give much detailed information due to confidentiality.
Mold Design: Pro Engineer
Product Design: Solidworks
Aircraft Tooling: Catia V5