NX 9 Sketch as reference

[George Packham]

Hi all,

I was wondering it is possible to set the sketch mode to sketch in reference rather than driven such that I do not need to select the line after drawing it and then selecting converting to reference. Or would it better to look into a journal or Macro for this?

Kind regards,
George Packham

 

[Toost]

It's not possible to draw reference lines in NX. The procedure is always draw a line ( any type curve in the sketcher) , then convert .
But, you can draw all and then convert all selected curves in one click.

Regards,
Tomas

 

[George Packham]

Thanks Tomas. I may resort to wavelinking the sketch for ease and speed.
Thanks