NX draft body

[kscnoname]

Hello,

I need the below shown draft of a tilted cylinder in NX (also attached NX part).
And the draft only needs to be added where necessary (not on all sides).

Currently this is done with a few features which are not really intuitive.
If I show this to our users I always get some frowns.
I need this in NX 9 but I also did not find a better/easier way in NX12.

Does anybody have a idea how this draft can be achieved in an easier way?

Thanks

Kscnoname

Unigraphics Key user

V13, V14, V15, V16, V17, V18, NX, NX2, NX3, NX4, NX5, NX6, NX7.5, NX8, NX8.5, NX9

 

[UGperson]

You could create a UDF. See attached file. Inputs needed for the UDF are 2 datum csys’s one for the sketch/extrude direction and one for split plane/Draft direction.