NX Post processor NC output Problem

[Arvii]

Hi everyone,

I have made my own post-processor in NX 12.0 for Siemens_840D Control.
I faced a little bit of a problem in NC output. can you guys have some solution?
as you can see in this program some arc didn't have CR=.


N1 G54 G17 G90 G64
N2 G0 Z8.
N3 M6 T0
N4 S0000 M3
N5 X.3125 Y.2499 Z.5
N6 Z-.9
N7 G1 Z-1. D0 F10.
N8 Y.4001
N9 G3 X0.0 Y.7126 CR=.3125
N10 X0.0 Y.7126 CR=.7126
N11 X-.3125 Y.4001 CR=.3125
N12 G1 Y.2499
N13 Z-.9
N14 G0 Z.5
N15 X.1458 Y-2.4608
N16 Z-.9
N17 G1 Z-1.
N18 G3 X-.1667 Y-2.1483
N19 G1 X-3.1667
N20 G2 X-3.9792 Y-1.3358 CR=.8125
N21 G1 Y.6642
N22 G2 X-2.6667 Y1.9767 CR=1.3125
N23 G1 X2.3333
N24 G2 X3.6458 Y.6642
N25 G1 Y-1.3358
N26 G2 X2.8333 Y-2.1483 CR=.8125
N27 G1 X-.1667
N28 G3 X-.4792 Y-2.4608 CR=.3125
N29 G1 Z-.9
N30 G0 Z.5
N31 M9
N32 M30

 

[Franklin M.]

Looks like you have modality problem. If the radii are the same the post isn't putting them out. As a quit fix make the radius non-modal in your post.

Franklin
UG 10,13 & 18
NX 1,2,4,6,11 & 12
NCL502 (yep I love Sequential Mill)

 

[Arvii]

Hi Franklin,

Can you please tell me how can I change the radius into no_modal?

 

[nxexplorer]

Hi Avril,

Have you checked the output status is active (in Word Sequencing)? sometimes it has been suppressed.
Another way is to make CR as a format, then make it enable in circular motion block.

Regards,
nxexplorer