NX1926 reference lines used for trim feature

[Lars1978]

Hi All,

I've been using the new sketcher to my sattisfaction. Only one thing I don't seem to figure .out why reference lines are used in subsequent feature.

Please see the link for the attached movie.

I've made a sketch with references (dashed lines) to other features in the model. With this sketch I trim a sheet face.

When I change the sketch the trim command starts using the reference lines?

Any way to resolve this strange behaviour?

https://www.dropbox.com/s/dy519koi90xwcac/reference as trim line.avi?dl=0

Kind regards,

Lars





Lars
NX native (NX13 or NX1847)
Solid Edge ST10
Inventor
Solidworks