Lars1978
Mechanical
- Dec 30, 2015
- 327
Hi All,
I've been using the new sketcher to my sattisfaction. Only one thing I don't seem to figure .out why reference lines are used in subsequent feature.
Please see the link for the attached movie.
I've made a sketch with references (dashed lines) to other features in the model. With this sketch I trim a sheet face.
When I change the sketch the trim command starts using the reference lines?
Any way to resolve this strange behaviour?
Kind regards,
Lars
Lars
NX native (NX13 or NX1847)
Solid Edge ST10
Inventor
Solidworks
I've been using the new sketcher to my sattisfaction. Only one thing I don't seem to figure .out why reference lines are used in subsequent feature.
Please see the link for the attached movie.
I've made a sketch with references (dashed lines) to other features in the model. With this sketch I trim a sheet face.
When I change the sketch the trim command starts using the reference lines?
Any way to resolve this strange behaviour?
Kind regards,
Lars
Lars
NX native (NX13 or NX1847)
Solid Edge ST10
Inventor
Solidworks