We just had our NX updated to version 1973 and when using the "Front", "Top" etc view operators, it no longer zooms to fit the model, but zooms in on the 0,0,0 datum. I can't seem to find an option in the customer defaults that sounds like it would fix this. I assume there's something like "Zoom to fit on operator" but for the life of me I can't seem to find this. Anyone know how to get it turned back on so clicking on a view has zoom to fit by default?
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
NX1973 Fit to view when using a view operator no longer zooms to entire part.
- Thread starter Isobar
- Start date
- Status
Similar threads
- Locked
- Question