NX4 Maintenance Release 4.0.4.2 Will Not Load

[Cad4Laser]

I have successfully loaded NX4 (64 bit) on Windows 7 Pro 64 bit).
I have downloaded MR 4.0.4.2 (64 bit) from Siemens web site.
When I execute the ugs_update.bat the dos window reads: This script will install NX 4.0.4.2 Maintenance Release files in:
"C:\Program Files\UGS\NX\4.0"
Press any key to continue...

This looks correct however when I run it, I receive many (can't create)warnings. Please see attached jpeg.

Mark -

 

[JohnRBaker]

Check you Windows profile and make sure that there's an environment variable by the name of 'UGII_BASE_DIR' and that it's set to the directory where you've installed NX 4.0.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

UG/NX Museum:

http://www.plmworld.org/p/cm/ld/fid=209

To an Engineer, the glass is twice as big as it needs to be.

 

[Cad4Laser]

It appears to be correct, please review attached jpeg.

Mark -

 

[JohnRBaker]

Looks correct.

Are you sure that you're installing a 64-bit update onto a 64-bit version of NX 4.0? You may wish to delete the upgrade kit you downloaded and start over.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

UG/NX Museum:

http://www.plmworld.org/p/cm/ld/fid=209

To an Engineer, the glass is twice as big as it needs to be.