Apr 21, 2008 #1 jerry1423 Mechanical Aug 19, 2005 3,428 Is there a way to dimension to an intersection point in NX5? ... if there is, I sure can't find it.
Apr 21, 2008 #2 jackley Automotive Sep 2, 2004 263 Can you add a theoretically intersection point and dimension to that? Not sure if it's the same as NX3.0, but under 'Insert - Symbol - Utility Symbol - Intersection', just pick the two edges you need and it creates it. Justin Ackley Designer Upvote 0 Downvote
Can you add a theoretically intersection point and dimension to that? Not sure if it's the same as NX3.0, but under 'Insert - Symbol - Utility Symbol - Intersection', just pick the two edges you need and it creates it. Justin Ackley Designer
Apr 21, 2008 #3 Xwheelguy Automotive Mar 17, 2004 2,048 I think you guys might need to add the icon shown in the attached image on the Selection Bar. I can dimension to intersections just fine. Tim Flater Senior Designer Enkei America, Inc. http://www.enkei.com Some people are like slinkies....they don't really have a purpose, but they still bring a smile to your face when you push them down the stairs. Upvote 0 Downvote
I think you guys might need to add the icon shown in the attached image on the Selection Bar. I can dimension to intersections just fine. Tim Flater Senior Designer Enkei America, Inc. http://www.enkei.com Some people are like slinkies....they don't really have a purpose, but they still bring a smile to your face when you push them down the stairs.
