TomLoughlin
Military
- Mar 14, 2014
- 18
Morning all,
I'm having problems when trying to rename a section view in NX 9.0.0.19. In the part navigator/drafting, I right click the view and in properties, I change the VWLETTER, VWLETTER_DISP and VWMANE from 'A' to 'AB'.
Whilst I'm at it, I also in the general tab, change the name to 'AB'.
All good so far.... But when I save the drawing and open it another time, sometimes it reverts back to 'A'. This seems very hit and miss as to when it works and when it doesn't. However, this morning I have discovered that when I move either the parent, or the section view, it reverts straight back to 'A' - this happens every time without fail.
What am I doing wrong? Is there a more reliable way to change a section view name?
Thanks
Tom
Contract Mechanical Design Engineer.
I'm having problems when trying to rename a section view in NX 9.0.0.19. In the part navigator/drafting, I right click the view and in properties, I change the VWLETTER, VWLETTER_DISP and VWMANE from 'A' to 'AB'.
Whilst I'm at it, I also in the general tab, change the name to 'AB'.
All good so far.... But when I save the drawing and open it another time, sometimes it reverts back to 'A'. This seems very hit and miss as to when it works and when it doesn't. However, this morning I have discovered that when I move either the parent, or the section view, it reverts straight back to 'A' - this happens every time without fail.
What am I doing wrong? Is there a more reliable way to change a section view name?
Thanks
Tom
Contract Mechanical Design Engineer.