Anton Liubimov
Mechanical
1. Is it possible to programmatically open a dialog box and fill in the parameters?
2. How to run a macro (not a Journal) using NXOpen?
2. How to run a macro (not a Journal) using NXOpen?
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
NxOpen, How to programmatically open a dialog box "Extrude"
- Thread starter Anton Liubimov
- Start date
- Status
1. Yes, but apparently only the File New and File Open ones.
2. It's possible, but very ugly:
2. It's possible, but very ugly:
- Thread starter
- #3
- Status
Similar threads
- Locked
- Question
- Question
- Locked
- Question