wn_007
Electrical
- Dec 5, 2016
- 4
thread380-378667
I am new to this forum. I have read a similar thread regarding the issue that I have referenced.
Basically on our Omada Laser it crashes the head on the M104 command. It goes to 0.00 no matter what I have tried including
M104 Z.5. I have looked at the cut conditions settings and the Z Retract Height / No End which is set to 50mm. All other paramaters for the Z Retract Height are set to 25mm.
I am new to this forum. I have read a similar thread regarding the issue that I have referenced.
Basically on our Omada Laser it crashes the head on the M104 command. It goes to 0.00 no matter what I have tried including
M104 Z.5. I have looked at the cut conditions settings and the Z Retract Height / No End which is set to 50mm. All other paramaters for the Z Retract Height are set to 25mm.