Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Opening the Part/Modeling file in Simulation?

Thread starter hydronicengr
Start date Jul 2, 2012

Status: Not open for further replies.

Jul 2, 2012

hydronicengr

Mechanical

I'm pretty new to NX so excuse the newbie question. I'm using NX 8 and whenever I open up a simulation file (.sim), it opens up the sim and fem file perfectly, but does not open up the .prt file where the model is located. I would like to open this file up to make some changes to the model.

Is it possible to open up the .prt model while having the sim or fem open?

Thanks!