Part (Model) to Drawing (Orthographic) file

[DAE62]

I am new using Catia V5, so my question is how to bring up a model in a (Drawing) file. NOTE: I have set up my sheet, but I haven't found a clear way to transfer my model to the current DRAFTING (Drawing) file.

Thanks in advance.

 

[ferdo]

Hi,

Did you search first the forum or the FAQ area?

Regards
Fernando

 

[DAE62]

I have been searching for the last two hours, but I haven't found what I am looking for. NOTE: Including FAQ. I want to specifically assign a root view (front) where all other views will project from it. The pre-defined options are not what I am looking for. They do not match my Part (model) views.

Thanks.

 

[PeterGuy]

what you want is good / training!!!

use view creation wizzard to define view layout. pick face or plane that is to be the front.

 

[DAE62]

Thanks!! The problem was I was clicking the face before I went to "Creation Wizzard".

 

[brengine]

Start/Drafting...?

Ken