kyoung21
Mechanical
- Dec 15, 2011
- 2
I am attempting to make an automated parting line for a molded plastic tube with varying dimensions per job. The first thing I tried was Sweep, however despite getting a good cavity subtraction tool through Sweep, I always found that the parting plane line took the liberty of banking around like a drunk pilot.
How can I get the parting line to sweep and stay normal to Z so I know the mold can be separated without damaging the part? AutoCAD 14 had the ability, but I don't seem to see it in AutoDesk Inventor 2012.
For automating the system I tried things like Silhouette Curves, but they don't reliably come through to make the Sweep automated. I need something robust that won't be finicky about added or deleted edges or curves such as I have observed trying to use Silhouette Curves.
Any thoughts? I know exactly how to do this in 14 but can't seem to figure it out in Inventor 2012.
Thanks for your help.
How can I get the parting line to sweep and stay normal to Z so I know the mold can be separated without damaging the part? AutoCAD 14 had the ability, but I don't seem to see it in AutoDesk Inventor 2012.
For automating the system I tried things like Silhouette Curves, but they don't reliably come through to make the Sweep automated. I need something robust that won't be finicky about added or deleted edges or curves such as I have observed trying to use Silhouette Curves.
Any thoughts? I know exactly how to do this in 14 but can't seem to figure it out in Inventor 2012.
Thanks for your help.