PC based vibration analyzer 1

[cgben]

I am needing a portable PC based vibration analyzer program.
I am hoping to install the program or use it in conjunction with a new Tablet PC. If anyone knows of such a device your knowledge would be greatly appreacitaed.

 

[dgallagher]

For multi channel analysis, National Instruments and Vibration Specialty Corp both make 4 channel cards for a PC that will perform FFT, O-scope functions. If you only need a single channel, here is a cost effective solution:

http://www.reliabilitydirect.com/vibrationmeterproducts/microvibe.htm

 

[lynnds]

I have used Sprectra Plus software. This was very easy to use. The web site is

http://www.telebyte.com/pioneer/

 

[Smasher]

Hi
We've got two Data Physics ACE PCMCIA card based FFT aalysers. It's got 2 inputs and 2 outputs, it can go to a bandwidth of 20kHz and up to 25000 fft lines.
When I first got the flyers from them they had the units in a tablet, but they can't get the tablets now so they ship them in laptops. We paid about £3500 for the basic card and £6000 ish for the card plus a laptop and other bits. Take a look at:

http://www.dataphysics.co.uk

For the cash they're not bad, I'll often prefer to use this as apposed to some of the more complex based systems.

 

[MASSEY]

I've used National Instruments LabVIEW. It worked good.

 

[cgben]

Smasher thanks for the post. That was just what I was looking for.
Thanks
Ben