Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Problem with Object source in siemens nx MCD

Thread starter Simemg
Start date Sep 9, 2022

Status: Not open for further replies.

Sep 9, 2022

Simemg

Mechanical

Hello

I ask for help using Object source command on Siemens NX MCD 1953, when I activate manually during execution it works as it supposed but if assign into an input signal it creates multiple copies instead only one.

Is there a problem of configuration or runtime parameters?

Thanks in advanced