Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

proe machining

Thread starter gang1
Start date Sep 24, 2003

Status: Not open for further replies.

Sep 24, 2003

gang1

Industrial

In proNC I used to get 3D solids (assemblies) for my cutting tools. In that case I'm supposed to be capable to preview BOMs for those tools in Tool_Window, tab "BOM". Actually I can do that but all the components of my tool are of type "GENERAL" (you can see it in the column "type&quot

.
What parameter should I introduce in 3D solids to reflect its type (cutter ar holder) in proNC correctly?

Thanks in advance