vonsteimel
Mechanical
- Oct 19, 2010
- 132
Greetings,
See the attachment.
I've been refreshing my memory of Pro/mechanica (Wildfire 2.0) and have ran into an odd problem.
I've built 2 quick beams. One is straight across, the other (shown in the attachment) has a small section removed. I've been running buckling analysis on them.
The first beam works fine. This one with a section removed, however, does not. Everything seems to come out alright but it is buckling perpendicular to the load!? Looked over everything multiple times but cannot figure out what is wrong.
Any suggestions?
Thanks,
VS
See the attachment.
I've been refreshing my memory of Pro/mechanica (Wildfire 2.0) and have ran into an odd problem.
I've built 2 quick beams. One is straight across, the other (shown in the attachment) has a small section removed. I've been running buckling analysis on them.
The first beam works fine. This one with a section removed, however, does not. Everything seems to come out alright but it is buckling perpendicular to the load!? Looked over everything multiple times but cannot figure out what is wrong.
Any suggestions?
Thanks,
VS