ProE WF5, Spacepilot

[cadbike]

I have installed WF5 & now the 1-6 buttons, fit & view buttons are not responding.
I have installed the lastest driver from the 3Dconnexion web site.
Has anyone else had this problem?

 

[cadbike]

This is on a 3Dconnexion Spacepilot

 

[mjcole]

Probably gonna take a while before the 3dconnection Toolbar is supported in WF5. The Driver may not have been updated to work with WF5 send an email to 3dconnextion or logitech and inquire about it.

I only recently was able to use it with WF4 before then it was missing. See if you can show the 3dconnextion toolbar with WF5.

Also check that the deice LCDs light up you may need to pop it out and re-connect the USB slot. You may see an error message when launching Pro/E if the device was not detected by the driver.

Michael

 

[cadbike]

The updated driver to suit WF5 has been released on the 3dconnexion download site, I have installed and all is working as before.