Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Projection area
- Thread starter alexten
- Start date
SandeepDesai1981
Mechanical
Alexten,
* Go to the sketcher workbench (selecting the plane on which you want the projection).
* Project the surface under consideration using Project 3d element command
* The resultant must be a closed polygon
* Now go to GSD workbench ans create a FILL for the polygon.
* Now Using 'Measure Item' Command, you can get the area.
* Go to the sketcher workbench (selecting the plane on which you want the projection).
* Project the surface under consideration using Project 3d element command
* The resultant must be a closed polygon
* Now go to GSD workbench ans create a FILL for the polygon.
* Now Using 'Measure Item' Command, you can get the area.
SandeepDesai1981
Mechanical
Alexten,
* Go to the sketcher workbench (selecting the plane on which you want the projection).
* Project the surface under consideration using Project 3d element command
* The resultant must be a closed polygon
* Now go to GSD workbench ans create a FILL for the polygon.
* Now Using 'Measure Item' Command, you can get the area.
The Method is lengthy, but it works
Regards,
* Go to the sketcher workbench (selecting the plane on which you want the projection).
* Project the surface under consideration using Project 3d element command
* The resultant must be a closed polygon
* Now go to GSD workbench ans create a FILL for the polygon.
* Now Using 'Measure Item' Command, you can get the area.
The Method is lengthy, but it works
Regards,
- Status