Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in

pump design and manufacture

Status
Not open for further replies.
kking

kking

Mechanical
Feb 17, 2003
5
0
0
GB
this is probably the easist queastion on this site . What are the current standards for pump design in Europe including any harmonised standards?
 
Status
Not open for further replies.

Similar threads

struct4me
  • Locked
  • Question
pump selection between Vertical Turbine (VT) and Mixed Flow Vertical (MV) pump for Raw water pumping 1
Replies
4
Views
25
1503-44
1503-44
Jharvey2525
  • Locked
  • Question
Seeking Advice on Discharge Pump Flange Loads and Pressure Thrust in Slurry Pump System
2
Replies
33
Views
55
GBTorpenhow
GBTorpenhow
Eric Kelly
  • Locked
  • Question
Reduced-Noise Gas Flow Design Guide and spreadsheet by Nelson and NASA 1
Replies
9
Views
23
Prometheus21
Prometheus21
WissamH
  • Locked
  • Question
Pump Selection
2
Replies
25
Views
35
swazimatt
swazimatt
human909
  • Locked
  • Question
A quick and basic question: Pipe flange design criteria 1
Replies
3
Views
13
LittleInch
LittleInch
Back
Top