Jan 19, 2024 #1 SmallInfo Petroleum Oct 30, 2017 104 0 0 PK Hi Experts I'm a bit confused about the differences between these highlighted points. Can you please help me understand them better? Thanks in Advance
Hi Experts I'm a bit confused about the differences between these highlighted points. Can you please help me understand them better? Thanks in Advance
Jan 19, 2024 1 #2 Maslov Mechanical Oct 18, 2023 25 0 1 CA If the nominal thickness exceeds 1-1/4" you must preheat your welds, or else you have to do PWHT. If the nominal thickness exceeds 1-1/2" you must ALWAYS do PWHT. Upvote 0 Downvote
If the nominal thickness exceeds 1-1/4" you must preheat your welds, or else you have to do PWHT. If the nominal thickness exceeds 1-1/2" you must ALWAYS do PWHT.
Jan 19, 2024 #3 SnTMan Mechanical Jan 22, 2005 6,780 0 36 US This is one of those rare cases where the Code language reads exactly as it means Regards, Mike The problem with sloppy work is that the supply FAR EXCEEDS the demand Upvote 0 Downvote
This is one of those rare cases where the Code language reads exactly as it means Regards, Mike The problem with sloppy work is that the supply FAR EXCEEDS the demand
Jan 23, 2024 Thread starter #4 SmallInfo Petroleum Oct 30, 2017 104 0 0 PK Thanks Maslov. SnTMan, its clear now. Upvote 0 Downvote