shabshab
Structural
- Jun 28, 2010
- 1
Dear All
I am working on impact analysis in ansys/lsdyna.I used shell 163 element for modeling. I have problem in reading the results.In the model I have two rigid walls in the top and bottom, top wall impacts the cell which is in between.
My problems are:
1. I dont have any force or reaction forces result.
2. I want result of rigid wall rwforc in ASCII results which is empty in my result files.
Any advise would be appriciated.
Best Regards
shabshab
I am working on impact analysis in ansys/lsdyna.I used shell 163 element for modeling. I have problem in reading the results.In the model I have two rigid walls in the top and bottom, top wall impacts the cell which is in between.
My problems are:
1. I dont have any force or reaction forces result.
2. I want result of rigid wall rwforc in ASCII results which is empty in my result files.
Any advise would be appriciated.
Best Regards
shabshab