TomMtz
Mechanical
- May 5, 2010
- 147
Hi friends
I have a situation with NX11 sketch. When I use reference lines in a sketch and apply "finish sketch", I can´t visualize the reference lines in "modeling".
I use the reference lines in modeling mode like a "check point".
someone of you know how can I get it?
Regards
Tom
NX11 Windows 10
I have a situation with NX11 sketch. When I use reference lines in a sketch and apply "finish sketch", I can´t visualize the reference lines in "modeling".
I use the reference lines in modeling mode like a "check point".
someone of you know how can I get it?
Regards
Tom
NX11 Windows 10