Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Revision Table Question

Status
Not open for further replies.

mmakm

Mechanical
May 9, 2001
21
US
Is there a way within a revision table to modify the default for the revision to be numeric rather than letters? When I insert a rev table it always starts with "A" so I change it to "01" when a second revision is added, it goes to "B" and not "02". I searched for a default setting, and didn't find one. Am I missing something?
 
Replies continue below

Recommended for you

Try Document properties\tables and look at 'Revision table, Alpha/Numerical control.
 
Thanks NHPilot! If it were a snake it would of bit me. Sometime you just need a slap in the face.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top