Seeing the whole picture

[WillBailey]

What setting do I have turned off? Using NX7.5.3.3, and when I pull a drawing from Teamcenter I will only see parts of the drawing. I can mouse around, and when I cross over something it will then show. Soon as I move the mouse, it will go away. Rather annoying, and I would like to see the entire thing.

 

[SamSlivinski]

This sounds like some sort of graphics issue. Is this happening in modeling or drafting?

Sam Slivinski
Using NX 6
Manufacturing/Aerospace

 

[WillBailey]

I'm in the drafting workbench, I can open a model just fine. Just checked to make sure.

 

[JohnRBaker]

While in your Drawing, try doing a...

View -> Operation -> Regenerate Work

If that does not help, then yes, check your graphics driver to make sure that it's up-to-date.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.