Shaft tolerance for bearing

[jor1492]

Hello all,

I have spherical roller bearing bearing with a diameter of 130mm, I want to fabricated a shaft to fit with this bearing. My question is what is a good tolerance range for the fabrication of the shaft?

Thanks in advance

 

[GregLocock]

Look it up in the bearing catalogue. There isn't just one fit required, depending on the exact configuration (rotating/stationary housing/shaft etc). I assume 130mm is the OD?

Here's the skf website, with downloads of their catalogues.

http://www.skf.com/group/products/b...bearings/spherical-roller-bearings/index.html

Cheers

Greg Locock


New here? Try reading these, they might help FAQ731-376

http://eng-tips.com/market.cfm?

 

[jor1492]

thanks greg,

Yes 130mm is the OD