Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

sheet Metal Flange NX4

Status
Not open for further replies.

ideasuser

Industrial
Mar 30, 2006
51
Hi
I sketched 4 sides polygon with 4 corners: 90 deg., 90, 80, 100. I extruded the sketch 1MM and convert it to sheet metal. I tried to create the flange with length 15, angle 90. I expect to get 1 edge 10 degree because it is the same angle from the base. But I got both edge 90 degree. Please help. Thanks.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor