Sheet Metal operation?............................... 1

[CAD2015]

Hi,
Please, look at the magenta area. How could I create it in NX?
Thanks

 

[JohnRBaker]

Could you provide at least a couple of appropriate orthographic views?

John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

http://www.plmworld.org/museum/

To an Engineer, the glass is twice as big as it needs to be.

 

[CAD2015]

Hi John,
Thanks for your message. I need to create the transition area. It seems to me to be a Sheet Metal operation, but I do not have much experience with that. There is an angle of torsion in that area(2.5 degree).

Thanks

 

[JohnRBaker]

That picture provides little or no help. BTW, what is the intended use of this model? You describe it as a 'study'. Does that imply that it's part of some curriculum or classroom assignment?

John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

http://www.plmworld.org/museum/

To an Engineer, the glass is twice as big as it needs to be.

 

[eex23]

Here I modeled it in nx7. is it close to your example?

 

[CAD2015]

Hi eex23,
Thanks for your reply. I use NX6, I can't open your link.....Can you give me a written describtion of the steps, please?

Thanks

 

[eex23]

here the same situation modeled in nx4.

 

[CAD2015]

eex23:
Thanks a lot. It looks nice. I was wondering if Sheet metal application has a feature (too) especially for this procedure......
What do you think?

Regards

 

[eex23]

I dont think so. It is not sheet metal part.