Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Slab Embed Plates
- Thread starter maramos
- Start date
structSU10
Structural
Hilti Profis does a good job at checking embeded anchors with varying thickness and edge distances.
You may want to check with Hilti, but it is my understanding that Profis does NOT check the plate itself - it assumes the plate you specify is good for bending. I use HASDAS (an old dos program) for plates with studs. Don't know what is currently available.
- Status
Similar threads
- Locked
- Question
