Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations SSS148 on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Smart lightweight view in NX8.5 and over

Thread starter cubalibre000
Start date Nov 15, 2013

Status: Not open for further replies.

Nov 15, 2013

cubalibre000

Mechanical

I'm testing NX9 before to switch all compartments to NX9 and I'm look to the new smart lightweight views.
A part to use with big assembly drawings, can the idea to use this setting very often for single parts or little assembly wrong ?
Which limitations are to use this setting to improve performance drawing in general ?
If the idea isn't wrong, how can resolve situation like the PDF attached ?

Thank you...

Using NX 8 and TC9.1