Template has slipped off Paper

[JDPinUK]

NX I-deas 6 m2
MasterDrafting
using a template my group uses daily.
On this occasion the template has moved on the main paper so that the template border on two sides is off the paper and not visible on screen or print.
Changeing paper size to larger does not bring the template back all into the paper view.
I tried to force the template back by creating a view off the paper, and by moving a view, but it is not possible to place a view off the paper.
I did not notice when the template moved off the paper or if it was off from the start of the drawing, but other new starts always have the template fully on the paper.

Please advise suggestions of how to move the template back onto the paper ? or do I just need to re-create the drawing again from scratch?
For want of another way of describing the problem, the drawing template origin seems to have moved on the paper to the extent that corner / 2 edges of the template are off the paper.

 

[JohnRBaker]

You really need to post this in the I-deas forum:

http://www.eng-tips.com/threadminder.cfm?pid=577

John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

http://www.plmworld.com/museum/

To an Engineer, the glass is twice as big as it needs to be.