Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

NXOpen: creating new file from a model template using wrapper functions

Status
Not open for further replies.

PrintScaffold

Mechanical
Sep 8, 2006
453
Hello everyone!
Is it possible to use legacy wrapper NX Open functions to create new file from a specified model template? I looked up UF_PART_new, but it only creates new file from Blank template.

 
Replies continue below

Recommended for you

Because you have certain limitations when custom BlockStyler window is open and a way to work around them is to use UF fucntions. Having said that, since asking the question I managed to solve the task using somewhat different approach.

 
Status
Not open for further replies.

Part and Inventory Search

Sponsor