I'm looking for a NCHRP 350- or MASH-certified temporary sign stand that uses bolted connections. We have plenty of telespar tubing, so I was thinking of using this one, but our shop welder can't weld the galvanized tubing. http://www.wsdot.wa.gov/NR/rdonlyres/31E74DC3-C8CC-4389-8A16-F4F7603AC099/64393/PortableDetourRouteMultipleSignAssemblyExamples4.pdf Thanks! "...students of traffic are beginning to realize the false economy of mechanically controlled traffic, and hand work by trained officers will again prevail." - Wm. Phelps Eno, ca. 1928

Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations SSS148 on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

temporary sign supports using bolted telespar posts?

Thread starter ACtrafficengr
Start date Jun 15, 2011

Status: Not open for further replies.

Jun 15, 2011

ACtrafficengr

Civil/Environmental

I'm looking for a NCHRP 350- or MASH-certified temporary sign stand that uses bolted connections.

We have plenty of telespar tubing, so I was thinking of using this one, but our shop welder can't weld the galvanized tubing.

http://www.wsdot.wa.gov/NR/rdonlyre...eDetourRouteMultipleSignAssemblyExamples4.pdf

Thanks!

"...students of traffic are beginning to realize the false economy of mechanically controlled traffic, and hand work by trained officers will again prevail." - Wm. Phelps Eno, ca. 1928