Thickness in different points

[fsh27]

There is any command to analyze thickness of a body in different points?

I´m using NX10

Airin
NX Designer

 

[csbk]

ANALYSIS --> Molded part validation --> Check Wall Thickness

or ANALYSIS --> More

CSBK

 

[Toost]

Is the analysis you want to perform what i can see in the image above ?
Then use "Measure Distance", ( You can use the Simple Distance as well) first select the bottom base face as "Start Point",( note, you want to select the face itself and NOT a point on the face.) then tick in the point snap above the graphic window "Point on face", then you can click repeatedly on the top face and for each click / position see the distance.

Is this what you desire ?

Regards,
Tomas