Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

tool assembly

Thread starter kb1977
Start date Jul 31, 2014

Status: Not open for further replies.

Jul 31, 2014

kb1977

Aerospace

This one has been bugging me for awhile. I have an AMG operation that was intially created using a "Tool Assembly" I don't want to use the tool assembly anymore I just want to use a "Tool" but it will not let me. In other words, if I do a replace tool command, the tool changes but its still a part of the assembly... Has anyone else run across this? If more detail is needed just ask. Thanks ahead of time..!